How to Set Up OneLaser Hydra 13? A Complete Guide from Brandt Workman

[travis]

Thinking about getting started with the OneLaser Hydra 13? Brandt Workman (from Bearded Builds Co) put together a step-by-step series to walk you through the entire setup—from unboxing to first cut.

Part 1: Unboxing & Crate Removal
See how the Hydra 13 arrives, what’s included, and clever tips to get a 1,000-lb laser safely off the pallet.

OneLaser Hydra 13 Unboxing & Setup Guide (Part 1) | Laser Machine Crate Removal

Part 2: Unwrapping & Inspection
Why checking tubes, power supplies & accessories before powering on is critical (and how to do it right).

Hydra 13 Laser Setup Part 2 – Unwrapping, Inspection & Accessories Overview (OneLaser)

Part 3: Installing Accessories
Inline fan, air pump, chiller, distilled water mix—everything you need to prep your Hydra for its first run.

Hydra 13 Laser Setup | Part 3 - Installing Inline Fan, Air Pump & Water Chiller

Part 4: Controller Overview & Beam Alignment
Learn the menus, test alignment, and ensure both tubes are perfectly dialed in for precision.

Hydra 13 Laser Setup (Part 4) | Controller Overview & Beam Alignment Check

Part 5: Connect to LightBurn & First Project
Skip RDWorks—set up in LightBurn 2.0, enter offsets, and run your first engraving.

Hydra 13 Laser Setup (Part 5) | Connect to LightBurn & Run Your First Project

Follow Brandt Workman and OneLaser Channel